Introduction
Adjusting a rubber watch strap to fit your wrist perfectly is a simple process that can be done at home with the correct tools and 5 easy steps. In this guide, we’ll walk you through how to measure, cut, and reattach your rubber strap so it complements your wrist perfectly.
Tools you Will NEed
- A soft surface to place your watch.
- A pair of scissors.
- Double ended spring bar tool (provided).
- Fine Tip Marker or Pen.
- Your new watch.
Prepare Your Workspace
Place a soft cloth or mat on your work surface to avoid scratching the watch or strap. This will keep everything stable as you measure and cut.
Step 1: Remove the Clasp
To avoid cutting errors and ensure an even fit, it’s helpful to first remove the clasp. Use the spring bar tool to release the clasp from the strap. To do this gently press down on the hole that lines up with the strap as shown in the picture. Once removed set the clasp and the 2 spring bars aside in a safe place.
Step 2: Measure Your Wrist
Start by placing the watch face down on your soft surface. Next wrap the watch strap around your wrist to get a rough sense of the length you need. Pinch the rubber strap where it overlaps or feels too long—this will help you estimate how much to trim.
Step 3: Mark the Strap
Using a fine-tip marker, make a small line on the strap where you think it needs to be cut. The picture illustrates the desired outcome after the cut has been made so try to mark the strap with this in mind. Alternatively you can count the number of holes that you need to leave on each side and make a note of this.
It’s best to start with a smaller trim first, you can always cut more if needed.
It may be that you have more segments on one side than the other. This is Perfectly normal! Not all wrists are symmetrical and often require different lengths of strap on each side of the watch.
Step 4: Cut the Strap
Using sharp scissors, carefully cut along the marked line. Make a clean, straight cut for a professional look. If you’re uncertain, start by cutting a little less than marked—it's always possible to trim more later.
Step 5: Test the Fit
Now it's time to re-attach the clasp and test the fit. Place the spring bar in the final hole of the rubber strap and re-attach the clasp using the spring bar tool.
Once assembled check if the fit is comfortable. It may be a little loose on this first attempt, which will indicate you are on the right track. If this is the case repeat the process and aim to cut one segment at a time to ensure you don't make it too tight.
The watch should sit snugly on your wrist without feeling too tight.